ATTENTION
SPONSORS ADVERTISE WITH US CLICK HERE FOR DETAILS |
|
V6FBody
Online's - Techbase: |
4th
Generation V6 FAQ: Parts List
|
LIST OF RECOMMENDED PARTS FOR MODIFYING THE V6
F-BODY
Cold Air Induction
Systems
Product: |
K&N FIPK |
Engine: |
3.4 ltr ,3.8 ltr (with adaptor) and
5.7 ltr |
Horsepower
Gain: |
10 HP (max) |
Price: |
$200, $250 for 3800 version |
Comment: |
look around on the net and they find
specials that sell it for about $160 |
Product: |
SLP Cold Air Intake System (dual
filter) |
Engine: |
3.4 ltr ,3.8 ltr and 5.7 ltr |
Horsepower
Gain: |
10 HP (max) |
Price: |
$190 (about) |
Comment: |
Best looking setup according too many
people ! |
Product: |
Morosso Cold Air Intake System |
Engine: |
3.4 ltr, 5.7 ltr |
Horsepower
Gain: |
10 HP (max) |
Price: |
$160 (about) |
Comment: |
Kind of like K&N FIPK, does the
same thing except at lower price. |
Exaust
Systems
Product: |
SLP V8 Exhaust System (take off) |
Engine: |
3.4 ltr, 3.8 ltr, and 5.7 ltr |
Horsepower
Gain: |
N/A |
Price: |
$50 |
Comment: |
Best bang for the buck you will ever
find! |
Product: |
Flowmaster Muffler |
Engine: |
3.4 ltr, 3.8 ltr, 5.7 ltr |
Horsepower
Gain: |
N/A |
Price: |
$50 - $100 |
Comment: |
Many versions, Bang for the buck ,
About the loudest you can get but it does tends to 'whine' at high rpm. |
Product: |
Dynomax / RKSport mufflers |
Engine: |
3.4 ltr, 3.8 ltr |
Horsepower
Gain: |
N/A |
Price: |
$100 - $225 |
Comment: |
Overall ood performer, in looks,
sound and performance. |
Product: |
Borla #11441 |
Engine: |
N/A |
Horsepower
Gain: |
N/A |
Price: |
$425 (around) |
Comment: |
Comment: Superb material quality,
typical Borla sound and looks very good, But too expensive for just a
muffler! |
Product: |
Edelbrock Catback System |
Engine: |
3.8 ltr |
Horsepower
Gain: |
N/A |
Price: |
N/A |
Comment: |
Good choice for the 3800 Series |
Product: |
B&B Tri-Flo Catback System |
Engine: |
3.8 ltr |
Horsepower
Gain: |
N/A |
Price: |
$600 + |
Comment: |
Like the Borla it has great sound and
looks, also made out of HIGH quality T-304 stainless steel but also very
expensive! |
Pulley
Systems
Product: |
Power Pulleys |
Engine: |
2.8 ltr, 3.1 ltr, 3.4 ltr, and 5.7
ltr |
Horsepower
Gain: |
10 - 15 HP |
Price: |
$70 (about) |
Comment: |
Look at Internet Race Supply on a
wide variety of pulleys! As of today there are NO pulleys available for the
3800. |
Ignition
Systems
Product: |
Spark Plug Wires |
Engine: |
All Engines |
Horsepower
Gain: |
Slight gain with plugs also |
Price: |
$40 - $70 |
Comment: |
Any low resistance wire (8-10 mm)
will be an improvement over stock ! The Reccomended brands are Taylor, Mallory,
Accel, and of course MSD. |
Product: |
Spark Plugs |
Engine: |
All Engines |
Horsepower
Gain: |
Slight gain with wires also |
Price: |
$2-$4 a piece |
Comment: |
We highly recommend using either the
AC Delco 'Rapidfire' or the Bosch 'Platinum' plug. The Splitfire plugs however
do NOT justify the high costs. NOTE: the Bosch platinum '4' melt when using
nitrous. They can't handle the heat. |
Performance Programmers
Product: |
JET Performance Chips |
Engine: |
ALL engines, except 3800 |
Horsepower
Gain: |
22 hp (peak) |
Price: |
$150-$250 (about) |
Comment: |
The pre 94 can get replacement
performance chips for their PCM, the 94-up 3.4 & engine can use a 'power
module' that will alter motor management. Some people experienced units that
were faulty, but those who have a working module are usually happy with it, the
price around $250 is too steep ... NOTE: Does NOT remove the speed
limiter. |
Product: |
Hypertech Power Programmer/Chips |
Engine: |
3.4 ltr, 3.8 ltr, and 5.7 ltr |
Horsepower
Gain: |
16 HP |
Price: |
$350 |
Comment: |
The HPP was available for the 3.4 But
not anymore . You'll have to check our
classifieds or Ebay for used HPP+'s An HPP
III is available from Hypertech for 2000 -
2002 3.8L part #30009. |
|
|
|
|
|
This website and all content contained herein is copyrighted
(C) 1996-2002.
V6FBody
Online - All rights reserved. Use acknowledges Terms
of Use Policy's
|